Removable conical anchor set

Description

Removable conical anchor, Used to fix the mold to concrete. Removable conical anchoring, which is a fast and cost -effective product, or carrot anchor usually in one -faced curtain patterns, In climbing molds, In tunnel molds, Dams, It is a valuable tool for console forms used in the construction of skyscrapers and other similar structures., 50 Authorized or more reuse factor can be obtained.

Is economic.It is removed again after the finishing of the disposable conical anchoring process 50 or reused more times. This product, It is much more economical than other applications..

Easy assembly
The product is installed in the mold very easily with standard bolts and is ready for concrete breakage..

Quick dismantling process
The product is slightly covered with grease before the installation phase and the dismantling switch is sufficient for breaking the bond with a single impact concrete, and then the anchor screw can be retracted within seconds.

Self -cleaning of teeth
Your beds in the teeth 2 It has important feature.
1- It allows the anchor dismantling switch to easily get into it
2- Cleans the teeth of screws and stabbing

Low recovery cost
Removable conical anchors normally, It is left in concrete until it is no longer necessary.. A combined rescue and blockage process, will reduce costs to a negligible factor.

Replaceability
If the anchor point is needed again at a subsequent stage of construction, It can be left without closing the hole and any conical anchor screw can be re -installed when necessary. Re -installed anchor, It will provide full load transport value.

Striege does not leave points.
After the anchor has been removed, there is no place behind it..

Low sealing costs
There is no need for expensive sealing materials to be waterproof because there is no possibility of rusting.. Spiral form left by the conical anchor screw, Provides mechanical assistance to the tap connection.

No special bolt required
Standard gear commercial bolts or stabbing are used to fix it to the anchoring screw.

There is no need to wait.
Conical anchors, When placing the molds, they are positioned in suitable places before concrete and move with concrete dumps. After concrete spilling process, any breaking drilling, etc.. It does not cause problems in terms of extra time and cost